A complete VFD installation includes drive sizing, panel mounting, line- and load-side protection, motor cable management, control wiring to the PLC or HMI, parameter configuration, autotune, and on-site commissioning under load. Each installation finishes with a parameter sheet and as-built drawings for the maintenance team.
VFD installation scope by Adgo Controls includes:
- Drive selection and sizing: Engineers match drive capacity to the motor’s full-load amps, duty cycle and ambient temperature so the drive operates within its thermal envelope.
- Power and signal wiring: Installation teams pull line-side feeders, load-side motor leads with shielded cable, and 24V control wiring to the PLC, HMI or remote operator station.
- Parameter configuration: Technicians enter motor nameplate data, control source, ramp times and protection thresholds.
- Autotune and commissioning: If the application requires sensorless vector control, the drive runs an autotune routine to identify the motor’s stator resistance and inductance before final commissioning.
- Documentation: Every project closes with a parameter sheet, as-built control drawings and a commissioning report.
Keep learning by visiting our VFD Configuration and Commissioning page or reading the answer to another FAQ: What is the difference between VFD configuration and VFD commissioning?
