Yes. Adgo network panels can be built with managed or unmanaged Ethernet switches, depending on the application. Managed switches are specified when the system requires VLAN segmentation, port-level diagnostics, redundant ring topology (RSTP, MRP or DLR), or remote monitoring via SNMP. Unmanaged switches suit simple, flat networks with no segmentation needs.
Managed switch selection for a network panel is driven by network architecture, not budget. The wrong switch class creates either a maintenance burden or a future migration cost.
- VLAN segmentation: Managed switches isolate OT, IT and guest traffic on the same physical infrastructure, a baseline requirement under IEC 62443.
- Diagnostic visibility: Port mirroring, SNMP traps and syslog forwarding flag a failing port before it disrupts production.
- Redundancy protocols: RSTP, MRP and DLR ring topologies recover from a single link failure in under 50 ms, faster than most PLC scan cycles.
- Industrial hardening: Switches inside a network panel are typically rated for −40 °C to +75 °C operation, fanless cooling and DIN-rail mount.
- If/then: If the application requires sub-100 ms SCADA polling, then the network panel build specifies a managed industrial switch with hardware-based ring redundancy.
For a custom-engineered switch-and-patch field built into a single factory-tested assembly, contact us today.
